GS108T Smart Switch Software Administration Manual

Advanced—LACP Configuration

The LACP Configuration screen lets you set the LACP system priority, which specifies the device’s link aggregation priority relative to the devices at the other ends of the links on which link aggregation is enabled. To configure LACP:

1.Select Switching > LAG > Advanced > LACP Configuration. A screen similar to the following displays.

Figure 4-5

The LACP System Setting field is the only configurable field in this screen:

LACP System Setting. LACP Port priority ranges from 0 to 65536. A higher value indicates a lower priority. The default value is randomly selected.

2.Click Apply to confirm any settings changes.

Advanced—LACP Port Configuration

The LACP Port Configuration screen, which is also referred to as the LACP Port Priority screen, lets you set the LACP port priority and time-out value:

1.Select Switching > LAG > Advanced > LACP Port Configuration. A screen similar to the following displays.

Configuring Switching

4-7

v1.0, December 2007

Page 51
Image 51
NETGEAR GS108T-100NAS manual Advanced-LACP Configuration, Advanced-LACP Port Configuration