GS108T Smart Switch Software Administration Manual

6.Make a note of the displayed IP address assigned by the DHCP server. You will need this value to access the switch directly from a Web browser (without using the Smart Wizard Discovery utility).

7.Select your switch by clicking the line that shows it. Then click the Web Access button. The

discovery utility displays a login window similar to the following:

.

Figure 1-2

Use your Web browser to manage your switch. The default password is password. Then use this screen to proceed to management of the switch, as covered in Chapter 2, “Introduction to the Web Browser Interface.”

Network without a DHCP Server

This section describes how to set up your switch in a network without a DHCP server, and is divided into the following tasks:

Manually assign network settings for your switch.

Configure the NIC settings on the host PC.

Log in to the Web-based switch management utility.

1-4

Getting Started with Switch Management

v1.0, December 2007

Page 18
Image 18
NETGEAR GS108T-100NAS manual Network without a Dhcp Server