GS108T Smart Switch Software Administration Manual

2.Select a radio button to enable or disable jumbo frames:

Disable. Jumbo frames are disabled. This is the default setting.

Enable. Jumbo frames are enabled.

3.Click Apply to confirm any settings changes.

Address Table

The Static Address table lists all the MAC addresses that you can specify. These addresses enable the switch to forward traffic from these MAC addresses. The maximum number of trusted MAC addresses is 256 per system. All source MAC addresses are trusted when the Trusted MAC list is empty. For information about the Trusted MAC list, see “Trusted MAC” on page 5-21. If the list includes MAC addresses, any incoming traffic with a source MAC address that is not included in the trusted MAC table is dropped.

Static Address

To configure a static MAC address:

1.Select Switching > Address Table > Static Address. A screen similar to the following one

displays.

.

Figure 4-22

2.The following static MAC address information is displayed. All fields are configurable:

Interface. Specifies the interface (port) number to which the entry refers.

MAC Address. Specifies the MAC address to which the entry refers.

VLAN ID. Specifies the VLAN ID to which the entry refers.

Configuring Switching

4-25

v1.0, December 2007

Page 69
Image 69
NETGEAR GS108T-100NAS manual Address Table, Static Address