GS108T Smart Switch Software Administration Manual

If you are starting with an “out-of-the-box” switch and are not using the Smart Wizard Discovery utility, you must initially configure your host PC to be on a network segment to match the default settings of the switch, which are as follows:

IP address: 192.168.0.239

Subnet mask: 255.255.255.0

Later, you might want to change the network settings to match those of your network (this procedure is described in “IP Configuration” on page 3-3). Your host PC network settings must then also be set back to match your network.

Clicking Web Access on the Smart Wizard Discovery utility or accessing the switch directly displays the following screen.

.

Figure 1-5

Use this screen to proceed to management of the switch, as covered in Chapter 2, “Introduction to the Web Browser Interface.”

Additional Utilities

Alternatively, from the main screen shown in Figure 1-1 on page 1-3you can access additional functions as described in the following sections:

“Password Change

“Firmware Upgrade

Getting Started with Switch Management

1-7

v1.0, December 2007

Page 21
Image 21
NETGEAR GS108T-100NAS manual Additional Utilities, Password Change Firmware Upgrade