
[JAM error]
• Does the JAM error occur when the power is turned on?
• Yes Is the paper at the inlet sensor?
• Yes Remove the paper.
▼
• No
• No
▼
• Yes
Is the operation of the inlet sensor lever normal (moves freely when touched)?
Replace the inlet sensor lever.
Clean the inlet sensor on the power supply board, or replace the power supply board.
▼
• No
Does the JAM alarm occur after paper feeding?
• Yes | Is the paper fed to the inlet sensor lever? |
•Yes Is the operation of the input sensor lever normal (moves freely when touched)?
• No | Replace the inlet sensor lever. |
▼
• Yes Clean the inlet sensor on the power supply board or replace the power supply board.
▼ | Replace the hopping roller rubber or separator assy. |
• No |
▼
• No
▼
• No
▼
• No
Is the hopping roller rotating?
• Yes | Set the paper tray properly. |
Is the registration motor rotating? | |
• Yes | Replace the |
| Is connector CN3 on the control board being connected |
| properly? |
| Exit roller |
• No | Connect connector CN3 properly. |
▼
• Yes
• No
▼
• Yes
Is the coil resistance (normal resistance: about
18.6Ω) of the registration motor normal (see 7.3)? Replace the registration motor.
Replace the Main Control PCB.
|
|
| Outlet sensor |
|
|
|
| Heat roller |
|
|
|
| Transfer roller |
|
direction |
|
| Paper sensor |
|
|
| Inlet sensor 1 |
| |
|
|
|
| |
running | Toner | Inlet | Paper |
|
end sensor | Registration roller | |||
| sensor | sensor 2 | Hopping |
|
|
|
|
| |
Paper |
|
| roller |
|
|
|
|
|
6 - 29