Oki 6E, 6ex specifications Yes

•( JAM error ) Paper Inlet Jam

•Does paper jam at the inlet when the power is turned on?

	• YES	Is the paper located above the sensor plate (Inlet)?
		• YES	Remove the paper.
	▼
	• NO	Is the sensor plate (Inlet) operating normally?
		• NO	Replace the sensor plate (Inlet).
	▼	Replace the power supply board or inlet sensor.
	• YES
▼
• NO	When the paper is fed in, does the paper inlet jam occur?
	• YES	Is the paper being fed to above sensor plate (Inlet)?
		• YES	Is the sensor plate (Inlet) operating normally?
			• NO	Replace the sensor plate (Inlet).
		▼	Clean the Inlet sensor on the power supply board or replace the
		• YES
			power supply board or Inlet sensor.
	▼	Replace the roller-A or roller-B.
	• NO
▼
• NO	Are the roller-A and roller-B rotating?
	• YES	Set the paper properly.
▼
• NO	Is the pulse motor turning?
	• YES	Replace planet gear.
▼
• NO	Is the connector cord being connected properly?
	• NO	Connect the connector cord properly.
▼	Check the coil resistance (approx. 32Ω) of the pulse motor.
• YES
	Is is normal?
	• NO	Replace the pulse motor.
▼	Replace the OLEV-11 PCB.
• YES

E - 20