3.3.6Roller-A and B
While only the removal procedure for roller-A is described here, the removal procedure for roller- B is basically same. When removing roller-B, however, be careful not to deform the sensor lever.
(1)Remove the upper frame (see 3.3.2 steps (1) through (3)).
(2)Remove the separator assembly (see 3.3.2).
(3)Remove the OLEV-11 PCB (see 3.3.3).
(4)Remove the motor bracket (see 3.3.5).
(5)Remove the gear 1.
(6)Shift the roller-A 2to the right, lift it on its left side and slide it out (the bearing 3also comes off while you are doing this, so be careful not to lose it).
2
3
1
Sensor Lever
Roller-B