
Setting
Example: Method for setting the parameter to 19 (for case where the previous parameter setting was 8).
Operation
Turn the POWER switch on while holding the FORM FEED and ENTER keys down.
Press the MENU key.
Press + or - key, until "19" is displayed.
Press the ENTER key.
Turn the POWER switch on while pressing the FORM FEED and ENTER keys.
LCD display after operation
ENG MNT
OPT HEAD | The item of “OPT HEAD” is | |
always | ||
600dpi head is used. | ||
| ||
LED HEAD | Displays previous | |
No. 8 * | parameter No. | |
LED HEAD |
| |
No. 19 |
| |
LED HEAD | Parameter 19 is | |
set to EEPROM | ||
No. 19 * | ||
(* is displayed on | ||
| ||
| LCD). | |
HEAD TYPE | There are two types of “HEAD TYPE” | |
available | ||
TYPE1 | The type is set as shown below | |
| according to the content of the | |
| bar code label attached on the head. | |
| Content of the bar code label on the head |
xxxxxx
. . . . .
XXX: HP4, AUT, WIN or HEX DUMP
73000123400101100
When the numeral of upper two digits under the bar code is 73, TYPE 1 is selected. When the numeral of upper two digits
under the bar code is 74, TYPE2D4 is selected.
XXX
4 - 16