Oki 6E, 6ex specifications

1Images are light or blurred entirely.

•Is toner low (is the TONER LOW message displayed)?

• Yes		Supply toner.
▼
• No	Is paper of the specified grade being used?
• No		Use paper of the specified grade.
▼	Is the lens surface of the LED head dirty?
• Yes
• Yes		Clean the lens.

▼

• No

• No

▼

• Yes

Is the LED head being installed properly (check connector CN4 (OKIPAGE 6e) or HEAD1, HEAD2 (OKIPAGE 6ex) of the control board and PC connector on the LED head for proper connection)?

Install the LED head properly.

Is the contact plate of the transfer roller in contact with the contact assembly of the power supply board properly (see Fig. 6-5)?

•Adjust the contact plate of the transfer roller to make a proper contact with the power supply board and shaft of the transfer roller.

▼	Are the contact of the developing roller and the contact of the toner supply roller		of
• Yes
	the image drum unit in comtact with the contact assembly properly (see Fig. 6-4		A
	and	B )?
• No		Adjust the contacts of the developing and toner supply roller to make a
		proper contact with the contact assembly.
▼	Replace the transfer roller.
• Yes
• Has the problem been removed?
• Yes		End
▼	Replace the image drum unit.
• No

•Has the problem been removed?

•Yes End

	Note: After replacing the image drum unit, set the printer in the user
	maintenance mode by turning the power on while pressing the MENU
	key and reset the drum counter (see User’s Manual).
▼	Replace the control board or power supply board.
• No

6 - 37