User Function Settings

User function settings allow you to customize the general operation of your MFP machine. Refer to the User Function Settings List to determine which settings you may need to change, then refer to Changing Your User Function Settings to make the change.

User Function Settings List

01 MCF (SINGLE-LOC.):This function automatically prints a Mes- sage Confirmation Report after each single-location transmission or polling transmission. Available settings are on and off.

02 MCF (MULTI-LOC.):This function automatically prints a Message Confirmation Report after each multiple-location transmission. Avail- able settings are on and off.

03 ERR REPORT (MCF): This function automatically prints a Mes- sage Confirmation Report each time an error occurs during a trans- mission or polling transmission operation. Available settings are on and off.

04 IMAGE IN MCF: When a message confirmation is printed, this function adds a portion of the first page your MFP machine transmit- ted. This is printed at the bottom of the message confirmation report. Available settings are on and off.

05 SENDER ID: This function controls the printing of your MFP machine’s Sender ID on the faxes you send. When turned on, your MFP machine’s Sender ID is printed on each page slightly outside the image area of your document. When turned off, your MFP machine’s Sender ID doesn’t print.

Note: In order to meet FCC requirements, you must have this feature set to ON and have a valid Sender ID programmed in your MFP machine.

06 MONITOR VOLUME: This function sets the volume your MFP machine uses for telephone line monitoring sounds during dialing. Available settings are off, low, mid, high mid and high.

66 OKIOFFICE 87 User’s Guide

Page 78
Image 78
Oki 87 manual User Function Settings List