Chapter 4. Key Telephone Features Section 700 - Operation
4-48 DBS Manual - Revised April 2000 DBS-2.3/9.2-700
Note: FF keys assigned as CO lines must be cleared using system
programming before new FF assignments can be made.
Operation
To assign pre-programmed codes to an FF key:
1. Press the
ON/OFF key:
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
2. Press the
PROG key.
“F” appears on the display.
3. Press the FF key to be programmed.
“Enter Code” appears on the display.
4. Enter the code to be programmed (see Table 4-6).
The programmed code appears on the display.
5. Press the
HOLD key.
“Code Stored” appears on the display.
6. Repeat steps 2-5 to program additional keys.
7. Press the
ON/OFF key.
The ON/OFF LED goes off.
To assign digits to an FF key:
1. Press the
ON/OFF key.
2. Press the
PROG key.
3. Press the FF key to be programmed.
“Enter Code” appears on the display.
4. Enter up to six digits.
5. Press the
HOLD key.