Section 700 - Operation Chapter 3. System Features
DBS-2.3/9.2-700 DBS Manual - Revised April 2000 Page 3-23
• FF1 (System): DISA Outbound Call ID Code 1
• FF1 (System): DISA Outbound Call ID Code 2
• FF2 (Trunk): DISA Auto Answer
• FF2 (Trunk): DISA Start Time
• FF2 (Trunk): DISA End Time
To program an incoming code from an attendant phone:
In addition to the DISA ID Setting in FF1, the following procedure can be
used to program an incoming code.
1. Press the
ON/OFF key.
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
2. Press the
CONF key.
3. Dial “#7.”
4. Enter the DISA code.
5. Press the
HOLD key.
6. Press the
ON/OFF key.
The ON/OFF LED goes off.
Hardware Requirements
• An MFR card is required for DISA. The MFR card is require d to detect
DTMF tones entered via the DISA connection.
Considerations
• DISA can be used to access e xtensions as well as outside numbers.
• Once an incoming DISA code is entered, you cannot blank it out without
entering the programming mode.
• Busy override cannot be used for a DI SA line.
• With CPC-A and CPC-B Versions 2.0 to 2.1, DISA calls cannot access
hunt groups.