5.Insert an 8-32 screw into the threaded hole in the front side of the roller pin and remove the pin. (See figure 3)
6.Remove the thumbscrew on the front side of the stacker rail base and let the square nut on the underside fall out. Loosen the thumbscrew on the far side to allow slack for the belts to slide on. (See figure 3)
FIGURE 4
7.Pull the drive away from the frame enough to allow the roller / belts to be lifted out of the frame. This will allow removal of the center roller / bearing assembly from the frame and provide “slack” sufficient to remove front roller from bearing blocks. (It is not necessary to loosen or remove the drive pulley to accomplish this step.) (See figure 4)
Users Manual Model 545™ | Maintenance • 65 |
