Raymarine 300 manual To make a new route by placing waypoints using the cursor

Chapter 3: Operation 3-25

The Route Building Table shows available Waypoints in the left hand column (in alphanumeric order). The right hand column contains the waypoints in the New Route. The number to the left of the waypoint name in the New Route column indicates its order in the route. The lower part of the table shows position, bearing and range of the highlighted waypoint.

3.Use the trackpad left/right to alternate between the two columns; the highlighted title indicates the selected column. Use the trackpad up/down to scroll through the lists.

4.Select a waypoint from the Waypoint List, go to the New Route col- umn and select a position in the list.

5.Press the INSERT WAYPOINT soft key to place the waypoint below the selected position in the Route.

6.To remove a waypoint from the New Route column, highlight the waypoint and press the REMOVE WAYPOINT soft key.

Notes: (1)A waypoint cannot be used more than once in a route; those al- ready used are grayed out.

(2)The INSERT WAYPOINT or REMOVE WAYPOINT action adds/re- moves the highlighted waypoint to/from the Route column, re- gardless of which column is selected.

3.When all waypoints have been entered, press the ACCEPT ROUTE soft key (or ENTER) to complete the route.

Note: The completed route is stored in the display unit and will be re-dis- played if you turn the unit off then on again. However, on an integrated system it is possible for a current route from another unit to overwrite this route; it is therefore recommended that you Save the route, as described in Saving the Current Route on page 3-27.

➤To make a new route by placing waypoints using the cursor:

Note: You can pan the display and change the scale whilst placing way- points.

1.Use the DISPLAY key to select Plotter mode.

2.If necessary, move the cursor to the area in which you wish to make the route and select a suitable scale.

3.Press the ROUTE soft key; the route soft keys are displayed as shown in Figure 3-30.

MAKE EDIT CLEAR

ROUTE ROUTE ROUTE MORE¬

D4913-1

Figure 3-30: Route Soft Keys