6-2

Raynav 300 GPS Plotter

Always report any EMC-related problem to your nearest Raymarine dealer. We use such information to improve our quality standards.

In some installations, it may not be possible to prevent the equipment from being affected by external influences. In general this will not damage the equipment but it can lead to spurious resetting action, or momentarily may result in faulty operation.

Disposal

When the unit reaches the end of its operational life, ensure its displosal is carried out in accordance with any local ordinances or requirements.

This may include specific disposal requirements for the back-up battery on the main PCB.

6.2 Resetting the System

Two types of reset are available:

Power-On Reset: When you turn the display unit off, then on again, the screen reverts to the default GPS plotter display.

Factory Reset: This resets all values back to their original factory set- tings.

Note: Take care; Factory Reset clears all Waypoint and Route databas- es.

At power-on, the last-used values are retained for all the options, except for those listed in Table 6-1which are reset to the factory default each time.

Table 6-1: Power-on Settings

Item

Power-on Setting

 

 

Heading Mode

North Up

 

 

Alarm

ON, with last used value

 

 

Contrast Level

Last used value or within 30% to 70% range, if last used value out-

 

side this range

 

 

Backlight

ON at the lowest level if previously ON

Level

 

 

 

To perform a Factory Reset:

1.Press the MENU key to access the SET UP soft keys.

2.Press the SYSTEM SET UP soft key.

3.Press and hold the MENU key until <RESET IN Xs> countdown timer is displayed.

Page 112
Image 112
Raymarine 300 manual Resetting the System, Disposal, Power-on Setting