Ricoh 3045 Troubleshooting, Error & Status Messages on the Display Panel, Status messages, 149

Troubleshooting

Troubleshooting

Error & Status Messages on the Display Panel

This section describes the principal messages that appear on the panel display. If a message not described here appears, act according to the message.

Reference

Before turning the main power off, see “Turning On the Power”, General Set- tings Guide.

❖ Status messages

Message	Status
Hex Dump Mode	In the Hex Dump mode, the machine receives data in hexadec-
	imal format. Turn off the machine after printing, and then turn
	back on.
Offline	The machine is offline. To start printing, switch the machine
	online by pressing [Online] on the display panel.
Please wait.	The machine is preparing the development unit. Wait a while.
Printing...	The machine is printing. Wait a while.
Ready	This is the default ready message. The machine is ready for
	use. No action is required.
Resetting job...	The machine is resetting the print job. Wait until “Ready” ap-
	pears on the display panel.
			8
Setting change...	The machine is setting changing. Wait a while.
Waiting...	The machine is waiting for the next data to print. Wait a while.
❖ Alert messages
Messages/Second messages	Causes	Solutions
Authentication has failed.	The login user name or pass-	Check your login user name
	word entered is incorrect.	and password.
	The machine currently cannot	Consult an administrator.
	perform authentication.
Ethernet board has a prob-	An error has occurred in the	Turn off the main power
lem.	Ethernet board.	switch, and back on again. If
		the message appears again,
		contact your sales or service
		representative.
HDD has a problem.	An error has occurred in the	Turn off the main power
	hard disk drive.	switch, and back on again. If
		the message appears again,
		contact your sales or service
		representative.

149