Ricoh 3045 Setting Thick Paper or OHP Transparencies, Press Horizontal, Select OHP or Thick Paper

Getting Started

HEnter the vertical size of the paper using the number keys, and then press [#].

1

IPress [Horizontal].

J Enter the horizontal size of the paper using the number keys, and then press [#].

KPress [OK].

The paper sizes entered are dis- played.

LPress [OK].

MPress the {User Tools/Counter} key.

❒Thick paper and OHP transparen- cies are delivered face up on the top of the preceding page; there- fore, the prints need to be rear- ranged into the correct order. To avoid this, select [Reverse order print] in the RPCS printer driver settings to deliver the prints in the correct page order.

Reference

For printer driver settings, see Printer Driver Help.

A Press the {User Tools/Counter} key on the control panel.

BPress [System Settings].

CPress the [Tray Paper Settings] tab.

DPress [TNext] to scroll through the list.

EPress [Paper Type: Bypass tray].

Setting Thick Paper or OHP Transparencies

Note

❒The following procedures are not required if you select [Driver / Com- mand] from [Bypass Tray Setting Pri- ority] in [System] of [Printer Features]

(see p.128 “System”). In that case, set the paper size using the printer driver.

❒If you select [Machine Settings] from

[Bypass Tray Setting Priority] in [Sys- tem] of [Printer Features] (see p.128 “System”), the settings made using the control panel have priority over the printer driver settings.

❒If the printer driver is not used, se- lect [Machine Settings] from [Bypass Tray Setting Priority] in [System] of [Printer Features] (see p.128 “Sys- tem”). Set the paper size using the control panel.

FSelect [OHP] or [Thick Paper].

GPress [OK].

The paper type selected is dis- played.

HPress the {User Tools/Counter} key.

Note

❒The settings made will remain valid until they are reset again. After printing on OHP trans- parencies or thick paper, make sure to clear settings for the next user.

16