Ricoh 3045 appendix 150

Appendix

	Messages/Second messages	Causes	Solutions
	IEEE 802.11b (Wireless LAN)	IEEE 802.11b interface unit	Turn off the machine and
	has a problem.	was not inserted when the ma-	check the IEEE 802.11b inter-
		chine was turned on, or it was	face unit is inserted correctly.
		pulled out after the machine	Then, turn the machine on
		turned on.	again. If the message appears
		The settings are not updated	again, call your service center.
		although the unit is detected,
		or errors are found while ac-
		cessing the unit.
	Memory Overflow	Maximum capacity of PCL or	Reduce the value of [Resolu-
		PostScript 3 list display has	tion] in the printer driver. Al-
		been exceeded.	ternatively, select [Frame
			Priority] from [Memory Usage] in
			[System] (See p.128 “System”).
			If this message continues to
			appear after taking these
			steps, decrease the number of
			files sent to the machine.
	Paper in staple tray. Open	There is paper remaining in-	Open the cover of the finisher,
	Finisher Cover and remove	side the finisher.	and remove the paper.
	paper.
	Parallel I/F board has a prob-	An error has occurred in the	Contact your sales or service
	lem.	parallel interface board.	representative.
	Printer font error.	An error has occurred in the	Check the font settings.
		font settings.
8	DToner is almost empty.	The toner has almost run out.	Replace the toner cartridge
			with a new one.
	USB has a problem.	An error has occurred in the	Turn off the main power
		USB interface.	switch, and back on again. If
			the message appears again,
			contact your sales or service
			representative.

150