Ricoh 3045 appendix Setting Paper on the Bypass Tray, For details about setting paper

Setting Paper on the Bypass Tray

Setting Paper on the Bypass Tray

This section gives instructions for set- ting paper on the bypass tray. Use the bypass tray to print onto OHP trans- parencies, labels, thick paper, and en- velopes that cannot be loaded in the paper tray.

Important

❒The following functions are disa- bled when printing from the by- pass tray:

•Duplex printing

•Auto Tray Select

•Auto Tray Switching

•Rotating Collate

•Staple (when the optional unit is installed)

•Punch (when the optional unit is installed)

❒When printing using the printer function, original images are al- ways rotated by 180 degrees (the orientation of images to be printed is opposite to that of the copier function). When printing onto pa- per with specific orientation re- quirements, such as envelopes and letterheads, make sure to rotate the paper feed orientation to 180 de- grees.

Reference	1
For details about setting paper in

the regular paper tray, see General Settings Guide.

When loading custom size paper, see p.15 “Setting Custom Size Pa- per”.

When loading OHP transparencies or thick paper (over 127.9 g/m2), set paper size and paper type. For details, see p.16 “Setting Thick Pa- per or OHP Transparencies”.

When loading letterhead paper, pay attention to its orientation. See “Orientation-Fixed Paper or Two- Sided Paper”, General Settings Guide.

Note

❒Paper within the following dimen- sions can be set in the bypass tray:

•Vertical: 100 - 297 mm (3.94 - 11.69 in.)

•Horizontal: 148 - 600 mm (5.83 - 23.62 in.)

❒Be sure to set the paper with the side you want to print facing down in the bypass tray.

❒The number of sheets that can be loaded in the bypass tray depends on the paper type.

❒Paper sizes fed from the bypass tray are output first sheet down, print side-up.

13