Ricoh 3045 appendix Machine Does Not Print, 151

	Troubleshooting
The Machine Does Not Print
Possible Cause	Solutions
Is the power on?	Check the cable is securely plugged into the power outlet and the
	machine. Turn on the main power switch.
Is the machine online?	If not, press [fOnline] on the display panel.
Does the printer function	If so, check the error message on the display panel and take re-
status indicator stay red?	quired action.
Is there a warning status or	If so, check the error message or warning status on the display
error message on the dis-	panel and take the required action.
play panel?
Does the “Updating the	The destination list is being updated from the network using
destination list...Please	SmartDeviceMonitor for Admin.
wait. Specified destina-	Depending on the number of destinations to be updated, there
tion(s) or sender's name
	may be some delay before you can resume operation. Operations
has been cleared.” message
	are not possible while this message is displayed.
appear?
	Wait until the message disappears. Do not switch off the power
	while this message is displayed.
Can you print a configura-	If you cannot print a configuration page, there maybe a machine
tion page?	malfunction. Contact your sales or service representative.
	See p.126 “Printing the configuration page” for printing a config-
	uration page.
Is the interface cable con-	Connect the interface cable securely. If it has a fastener, fasten that
nected securely to the ma-	securely as well.
chine and computer?	See p.10 “Connecting the Machine”.
Are you using the correct	The type of interface cable you should use depends on the compu-
interface cable?	ter. Be sure to use the correct one. If the cable is damaged or worn,
	replace it.
	See p.10 “Connecting the Machine”.
Was the interface cable	Connect the interface cable before turning on the machine.
connected after the ma-
chine was turned on?
Is the signal status satisfac-	To check signal status, press {User Tools/Counter} key on the dis-
tory when using wireless	play panel, and then press [System Settings] on the display panel.
LAN in the infrastructure	On the [Interface Settings] tab, select [IEEE 802.11b], and then press
mode ?	[Wireless LAN Signal]. If signal quality is poor, move the machine to
	a location where radio waves can pass or remove objects that
	might cause interference.

Note

❒You can check signal status only when using wireless LAN in the infrastructure mode.

When using wireless LAN, Check using the machine's display panel that the SSID is correctly set. is the SSID correctly set?

8

151