Sanyo DSR - 300 manual Alarm and PRE-ALARM Recording, Alarm recording, Set alarm recording

4ALARM AND PRE-ALARM RECORDING

[EXIT/OSD] button

Alarm recording

Follow the procedures below to have the digital video recorder record an alarm image only when alarm input is detected.

zConfirm that the cable of the device required for alarms is connected to the ALARM terminal. (JP. 16)

zWhen the motion sensor is set, an alarm image is recorded when a moving subject is detected. (JP. 67)

1 Set alarm recording.

The default settings are shown below.

See P. 65 for how to change these settings.

z“ALARM RECORDING”: “OFF” Alarm recording is disabled.

z“DURATION”: “1 SEC”

Recording is performed for 1 second for each alarm signal received while the alarm is set.

2 When alarm input is detected

When an alarm is generated, the display below appears in the operation display area, and an alarm image is recorded.

		z
05- 10- 04	ALARM		0001	Counts the number
10: 50: 00	EN		10FPS	of alarms.

z“ALARM” appears in the operation display area.

zWhen an alarm is generated on a channel that is already alarm recording, the alarm recording time is

ALARM FULL indicator

ALARM indicator

FULL indicator

extended counting from that moment. The new alarm is not counted.

zThe latest 9,999 alarms are displayed in the alarm history (recording list). (Although the history can record up to 16,000 items, only 9,999 of these can be displayed on-screen.)

zThe panel’s ALARM indicator flashes.

zIf an alarm occurs during normal recording or timer recording, the recording operation will be ended, and it will restart after the end of alarm recording.

zWhen the normal recording area is set to “*1%”, alarm recording is possible for the complete memory available in the alarm recording area. For “1%” and other settings, up to 16,000 items are recorded per hard disk. However, if set for *1%, “ALARM SEARCH”, “ALARM THUMBNAIL SEARCH”, and “MOTION DETECTION SEARCH” will not be available. Use “TIME/DATE SEARCH” instead.

Furthermore, since the alarm skip function will also be inactive, it will be necessary to carry out fast-forward and fast-rewind playback.

3 End alarm recording.

When the alarm duration time ends (default setting: 1 second), “ALARM” disappears from the operation display, the ALARM indicator stops flashing, and recording stops.

zWhen the space remaining in the alarm recording area drops below the setting value, the FULL indicator lights and recording stops. You can start recording from the beginning again by changing the recording setting. (JP. 57)

„If recording is ended during alarm recording using the motion sensor

Set “LEVEL” from the motion sensor screen to “OFF”. (JP. 67)

OPERATION

24 English