Sanyo DSR - 300 Setting the motion sensor, Move the cursor to Motion Sensor and press the button

8ALARM REC MODE SET

zThis unit’s motion sensors cannot be used when a multiplexer is connected. In such a case, please use the multiplexer’s motion sensors.

zWhen using the multiplexer’s motion sensors, connect the alarm output on the multiplexer to this unit’s alarm input.

zWhen using a multiplexer, connect its ground terminal and the recorder's ground terminal.

Setting the motion sensor

If a motion sensor is set on the monitor, alarm recording will be carried out when a moving subject is detected.

1 Move the cursor to “MOTION SENSOR” and press the [ ] button.

The motion sensor screen is displayed.

Motion sensor screen

2 Press the [ ] or [ ] button to select sensor operation positions (up to 80), then press the [ ] or [ ] button to confirm the selection.

Press the [ ] or [ ] button to turn sensors “ON” (shown as ) and “OFF” (shown as ).

Setting example

3 Move the cursor to “LEVEL”, then press the [ ] or [ ] button to change the setting.

[Settings] (‹ indicates default setting.)

Setting	Description
‹OFF	Not carried out
1 to 10	Motion sensing will be carried out. Lower values
	correspond to higher sensitivities.

4 Move the cursor to “EXIT”, then press the [ ] or [ ] button to return to the <ALARM REC MODE SET> screen.

5 Press the [EXIT/OSD] button.

The display returns to the normal screen.

„If recording is ended during alarm recording using the motion sensor

Set the sensitivity from the motion sensor screen to “OFF”. (See the procedure 3.)

zPressing the [MENU RESET] button in the motion sensor screen sets the entire row in which the cursor is located.

English 67