Sanyo DSR - 300 101, Total capacity display, Area-specific capacity display, Recording area reset

2 MENU-SPECIFIC SETTINGS

(when optional interface board is installed)

4. RECORDING AREA SET

The unit’s hard disk is separated into three independent recording areas. Furthermore, five different recording modes can be used for these three areas.

The memory capacity for each area is allocated as a percentage. (Setting units: 1%)

Recording area	Recording mode		Recording method
	Normal	Manual	Recording is performed in response to manual operation of the operation panel’s
Normal	recording		button.
recording area	Timer recording	Automatic	Recording is performed automatically over the time range set using “7. TIMER SET” from
			the MAIN MENU.
	Alarm recording	Automatic	Recording is performed automatically upon occurrence of an alarm set using “9. ALARM
			REC MODE SET” from the MAIN MENU.
Alarm recording
			Automatic recording of images before an alarm is performed automatically in
area	Pre-alarm	Automatic
	recording		accordance with “PRE-ALARM RECORDING” from the MAIN MENU’s “9. ALARM REC
			MODE SET”. This is used as a complementary function for alarm recording.
Archive area	Copy	Manual	The required images are copied from another recording area and stored in response to
			manual operation of the operation panel’s	button.

(1) Total capacity display

This section displays the total capacity of the hard disk.

(2) Area-specific capacity display

This section displays the capacity set by the unit for each recording area as a percentage of the total capacity.

zSetting and modification of recording area capacities cannot be carried out from a PC.

(3) Recording area reset

When the overwrite setting is “OFF”, recording will be automatically stopped when the corresponding recording area has been filled with image data. In such a case, [AREA FULL RESET] can be clicked to clear all recorded data and to restart recording from the beginning of each area.

The ability to perform a reset will not be required in the following cases, and for this reason, [AREA FULL RESET] is not displayed.

zWhen the overwrite setting is “ON”.

(1)

(2)

(3)

English 101