Sanyo DSR - 300 manual 121, Select 5. Motion Detection Search from the Search menu

4 OPERATIONS IN SEARCH MODES

(when optional interface board is installed)

5. MOTION DETECTION SEARCH

By setting images recorded in the hard disk’s normal recording area or alarm recording area to the motion sensor, variations from these images as a result of the presence of an intruder or the like can be detected, and the corresponding images can be played back.

(1) (4) (6)

(2)

(3)

(5)

(7) (8)

(1) SEARCH FROM

The recording area to be used for motion searching

(2) MULTIPLEXER CHANNEL

The channel of the multiplexer (camera number) to be used for motion searching

(3) START/END

The date and time of the start and end of the memory area for motion searching

(4) [SET]

Detection condition settings

(5) Message box

This box displays the results of searching for motion- detection images

When searching	“SEARCHING”
When motion-detection	“FOUND”
images exist
When motion-detection	“IMAGES NOT FOUND!”
images do not exist

(6) MOTION SENSOR SET

Screen for making motion sensor settings

(7) MOTION SENSOR LEVEL

Motion sensor sensitivity setting: OFF or 1 through 10

(8) [PREVIEW]

Displays a preview of the detection image

1 Select “5. MOTION DETECTION SEARCH” from the SEARCH menu.

The motion detection search screen is displayed.

2 Specify the recording area to be used for motion searching with “SEARCH FROM”.

[Settings] (‹ indicates default setting.)

Setting	Description
‹ALARM	Searching will only be performed for images
	in the alarm recording area.
NORMAL	Searching will only be performed for images
	in the normal recording area.
ALARM &	Searching will be performed for images in the
	alarm recording area and normal recording
NORMAL
	area.

3 Specify the channel (or camera number) for searching using “MULTIPLEXER CHANNEL”.

If no multiplexer is being used and the number of channels is one, “-” will be displayed here.

4 Click [SET].

The date and time of the start and end of recording of motion detection images is displayed in “START” and “END” respectively.

zUse “START” and “END” to make new date and time settings when the searching range is to be reduced.

zThe results of searching will be displayed in a message box when [SET] is clicked.

5 Setting motion sensor detection conditions.

zMotion sensor positions

The motion sensor setting screen shows an 8 x 10 (height x width) grid of sensors, and when one of these sensors is clicked, the corresponding sensor setting mark will turn red. If the same location in the grid is clicked once again, the motion sensor will be deselected.

zMotion sensor sensitivity

Lower numbers correspond to higher levels of sensitivity, and a setting should be made from the pull- down menu.

6 Click [PREVIEW].

A search is carried out within the specified area for images in which motion was detected, and these images are then listed in recording sequence in the preview screen.

7 Click the preview screen for the image to be played back.

Full-screen playback will start.

English 121