Sanyo DSR - 300 manual 108, Display SET, Set the motion sensor level

2 MENU-SPECIFIC SETTINGS

(when optional interface board is installed)

Setting motion sensors

You can specify the position of motion sensors on screen as described below. Alarm images are recorded when a moving subject is detected at the specified position.

11 13 12 Setting example

11 Set the motion sensor level.

[Settings] (‹ indicates default setting.)

Setting	Description
‹OFF	Motion sensing is not carried out.
1 to 10	Motion sensing will be carried out. Lower values
	correspond to higher sensitivities.

12 Click the location where the motion sensor is to be setup.

“ON” (displayed ) is displayed for the corresponding sensor.

Click again to turn the sensor “OFF” (i.e., no display).

13 Click [SAVE].

The new settings are saved.

10. DISPLAY SET

Set conditions for the display of data on the unit’s monitor by selecting “ON” or “OFF” for each item.

1

2

zThese settings apply to information displayed on the monitor connected to the unit, not to the PC monitor’s display information.

1 Select “ON” or “OFF” for each data display item.

Item	Default	Description
	setting
DATE	ON	Sets whether the current date or recording
		date will be displayed.
TIME	ON	Sets whether the current time or recording
		time will be displayed.
QUALITY	ON	Sets the picture quality for recording or
		playback.
REC	ON	Sets the recording rate for recording or
RATE		playback.
ALARM		Sets a maximum display quantity of 9,999,
	ON	and when this is exceeded, counting
COUNT
		restarts from 0.
		Sets the alarm recording type.
ALARM		z “ALARM” is displayed for alarm
	ON	recording.
TYPE
		z “PRE” is displayed for pre-alarm
		recording.

2 Click [SAVE].

The on-screen data display conditions are set or modified.

NETWORK SETTINGS

108 English