Sanyo DSR - 300 manual Replacing a Removable HDD, Replacement, Assemble and tighten the 4 screws

2REPLACING A REMOVABLE HDD

A separately-sold hard disk tray (VA-DT300) can be installed to facilitate easier storage and replacement.

zWhen replacing with a HDD used in a DSR-300; Of the menu settings, only the recording area settings and the overwrite on/off setting are used for the HDD.

zWhen replacing with a HDD used in a DVR other than a DSR-300;

It is treated as a new HDD. The recorded contents will be initialized.

zAbout the HDD;

Install an HDD provided by Sanyo. If an HDD supplied by a company other than Sanyo is used, Sanyo cannot be responsible for failures in performance or operation.

Replacement

zAlways set the HDD as the master.

The recorder will not operate if slave or cable select is set.

zIn cases where the HDD is not set as the master, or for whatever reason, it is not recognized by the unit, remove the power plug from the wall outlet, wait for approximately 30 seconds, and then remove the HDD.

1 Connect the removable HDD’s connector and place the HDD inside the tray.

Remove the brown antistatic sheet inside the tray.

zAssemble the two sockets in such a way that the red wires are positioned within them.

2 Assemble and tighten the 4 screws.

*Screw tightening torque: 0.5 to 0.6 N•m Use a non-slip torque screwdriver.

zWhen tightening the screws, ensure that both screws on the same side are tightened first. Tightening diagonally may result in the HDD being strained.

zOnly the supplied screws should be used. (Inch-system screws are used for assembly; accordingly, the use of other screws may result in the HDD or screw threads being damaged.)

3 Replace the cover.

Slide the cover over the case until the clasp locks into place.

Clasp

4 Place the removable HDD tray inside the unit.

Push in the HDD tray as far as it will go.

INTRODUCTION

Red wires

10 English