SATO GL4XXE manual Printer Management Mode Table, Menu, Description

	Unit 4: Printer Configuration
	PRINTER MANAGEMENT MODE (TABLE 4-16)
MENU	DESCRIPTION
	Is the menu selection screen for the Printer Management Mode.
Printer Mgmt
SNC Port
Mgmt Protocol
SNC Port Number
SNC Port Timeout
Status Port Numb
Mgmt Port Number
	SATO Net Connect Port. Allows selection of which port the printer expects SNC to connect with
	via Ethernet or Serial.
SNC Port
	• Disable - factory default. Not activated.
Disable*
Serial	• Serial - connects to serial port.
Ethernet	• Ethernet - connect to ethernet port.
	This menu selects the active Management Protocol Interface. Any system that supports the XML
	standards and schemas can work with PXML. UCP is used mostly for GPIO (General Purpose
	Input/Output) devices.
Mgmt Protocol
	Since PXML and UCP management protocols share the same Ethernet port, only one can be
PXML*
	active at a time.
	The options are PXML or UCP, and the factory default is UCP.
	This menu selects the port number the printer sends the emulation status. This is the Ethernet
	port number the emulations can use to communicate status to the host computer.
Status Port Numb
	The allowable range is 1023 to 65535, and the factory default is 3001.
XXXXX*
	Allows the Ethernet port number to be selected that the PXML or UCP will use to communicate to
	the printer. This is the Ethernet Port number the PXML or UCP will use to communicate to the
Mgmt Port Number
	printer.
XXXXX*
	This menu selects the port number the printer expects the SNC to connect through.
	The allowable range is 1023 to 65535, and the factory defualt is 3001.
SNC Port Number
XXXXX*
	If the SNC has not communicated to the printer within the period specified here, the SNC session
	closes.
SNC Port Timeout
	The allowable range is 1 to 255 seconds, and the factory default is 100.
100 seconds*

Allows the appropriate port option to be chosen.

	•	Debug - factory default. If the PNE port is set to Serial, then the PNE will communicate
Select Port
Debug*		through the Debug Serial Port.
Host	•	Host - if PNE is set to Serial, the PNE will communicate through the Host Serial Port. This
		cannot be selected if the host interface is set to Auto-Switch or Serial.

GL408-412e Operator’s Manual 4-86