SATO GL4XXE manual Wireless Local Area Network Wlan Interface Mode, 9, WLAN Interface Mode, 4-12

Unit 4: Printer Configuration

WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE

This chapter provides the programming sequences required for WLAN interface setup. Use the keys of the printer’s operator panel to select and enter the required options.

Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

ATTENTION: Perform the following programming sequence only if this is the interface type to be used. Instead, refer to the appropriate interface programming chart.

Screens

only display if Admin User is enabled within the Advanced Mode

POWER
ONLINE			A
			INTERFACES	INTERFACES
			Host Interface*	Host Interface*
LINE
			Host Interface	Host Interface
OFFLINE			Auto Switching*	Ethernet*
			C
			C
ENTER
			INTERFACES
INTERFACES			ETHERNET SETTING
			ETHERNET SETTING
			NetBIOS Protocol
Interface			NetBIOS Protocol
Mode
ENTER			Enable*
				D
INTERFACES			ASCII Data Port	WLAN ADDRESS
Ignore CR/LF			1024*
				IP Address
Item No. Check
				Subnet Mask
BCC Check
			Keep Alive Timer	Gateway Address
History Buffer
				MAC Address
Comm. Protocol			3 minutes*
	A			DHCP
Host Interface		B
ETHERNET PORT	C		Ethernet Speed
ETHERNET SETTING		D		IP Address
WLAN ADDRESS			Auto Select*
				XXX.XXX.XXX.XXX
WLAN SETTING	E
Parallel Port
USB Port			Job Control	Subnet Mask
Serial Port			Standard*
Printer Mgt				XXX.XXX.XXX.XXX
			Offline Process	Gateway Address
			Disable*
Ignore CR/LF				XXX.XXX.XXX.XXX

No*
	B	MAC Address
		XXX.XXX.XXX.XXX
Item No. Check
Disable*
	INTERFACES	DHCP
	ETHERNET PORT	Disable*
BCC Check
Disable*
	ETHERNET PORT
	Timeout
History Buffer
Temporary*
	Timeout
	10 sec*
Comm. Protocol
Status 5*
	Switch Out On
	Data Timeout*
A

Figure 4-9, WLAN Interface Mode

GL408-412e Operator’s Manual 4-12