SATO GL4XXE manual User Mode Table, Menu Description

	Unit 4: Printer Configuration
	USER MODE (TABLE 4-1)
MENU	DESCRIPTION
	Specifies the distance to advance or retract the print image on the label to determine its vertical
	positioning. The actual image height is not affected by this adjustment, only its location.
Ver Print Offset
	The factory default is -1.00inches with a range of 6.00 inches. A negative value (-) retracts the
00.0 mm*
	image and a positive value (+) advances the image placement on the label.
	Specifies the lateral distance to move the print image on the label to determine its horizontal
	positioning. The actual image width is not affected by this adjustment, only its location.
Hor Print Offset	The factory default is 0.00 inches with a range from -1.00inch to +1.00 inch. A negative value (-)
00.0 mm*
	moves the image closer to the printer’s center frame and a positive value (+) moves the image
	from the printer’s center frame.
	Typically specifies the physical label length of the media installed. However, the type of media in
	addition to its size it a determinant.

•Die-Cut Labels - the measurable length of the removable label. Does not include the liner material or gap.

•Tag Stock w/ notices or holes - the measurable length is from the trailing edge of one notch

		or hole to the leading edge of the next notch or hole.
Label Length
152 mm*	•	Tag Stock w/ black marks on underside - the measuarable length from the leading edge of
		one black mark to the leading edge of the next black mark.
	•	Continuous Media w/o indicators - the measurable length depends upon the image size.
	The allowable label length is from 0.1 to 0.99 inches (2.5 - 2514.6mm). The factory default is 6
	inches. The label length allowable is dependent on the label’s width and the printhead resolution
	in use.
	Specifies the physical width of the print image. The allowable range is 0.1 to 4.1 inches (2.5 -
	104mm).
Label Width
104 mm*
	Deternimes if a zero is printed with or without a diagonal slash through it.
Slash Zero
Disable*
	This setting determines whether each printer character occupies a designated space (Fixed)
	regardless of the character’s width, or if the character’s space is representative of its width
Character Pitch
	(Proportional).
Proportional*
	Proportional is contemporarily perferred.
	The ESC sequence in SBPL commands may be defined as standard (using non-printable code
	1BH) or non-standard (Hex 5E).
Protocol C. Code
Standard*
	Changes the address of the Euro character.
Euro Character
213*

GL408-412e Operator’s Manual 4-23