SATO GL4XXE manual Centronics Interface Mode

Unit 4: Printer Configuration

CENTRONICS INTERFACE MODE

This chapter provides the programming sequences required for Centronics interface setup. Use the keys of the printer’s operator panel to select and enter the required options.

Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

ATTENTION: Perform the following programming sequence only if this is the interface type to be used. Instead, refer to the appropriate interface programming chart.

POWER

ONLINE

LINE

Ignore CR/LF No*

Item No. Check Disable*

BCC Check

Disable*

History Buffer Temporary*

Comm. Protocol Status 5*

OFFLINE

FUNCTION

INTERFACES

Interface

Mode

ENTER

INTERFACES

Ignore CR/LF

Item No. Check

BCC Check

History Buffer

Comm. Protocol

Host Interface

Parallel Port

USB Port

Serial Port

Printer Mgmt

Screens

only display if ENTER Admin User is

enabled within the Advanced Mode

Timeout 10 sec.*

Report Status Disable*

Prime Signal

Disable*

Data Polarity

Standard*

Response Polarity Standard*

Busy on Strobe Enable*

Latch Data On 10 sec*

Offline Process Disable*

Host Interface Auto Switching*

Parallel Port Port Type

Port Type

Centronics

Data Bit 8

Enable*

PI Ignored

Enable*

Buffer Size in K 16*

Auto Trickle Disable*

Trickle Time 1/4 sec*

Host Interface Centronics

Parallel Port Port Type

CENTRONICS Data Bit 8

Data Bit 8

Enable*

PI Ignored

Enable*

Data Polarity Standard*

Resp. Polarity Standard*

Busy on Strobe Enable*

Latch Data On Leading*

Prime Signal Disable*

TOF Action

Reset*

Buffer Size in K 16*

Figure 4-6, Centronics Interface Mode

GL408-412e Operator’s Manual 4-9