SATO GL4XXE manual IGL Emulation Mode Table

		Unit 4: Printer Configuration
		TGL EMULATION MODE (TABLE 4-13)
MENU		DESCRIPTION
	Defines which media mode TGL will operate on receipt of a ‘D’ (strip mode) from the issue mode
	parameter in the XS command. Any of the supported media modes can be selected. When
XS Media ‘D’ Act
	Ignore is selected, TGL will use the issue mode as configured through Media Handling under the
Tear-Off*
	Media Control menu.
	The factory default is Tear-Off.
	AR Pre-Feed Command. Allows the selection of how the printer will respond to command for a
	paper pre-feed (AR).
AR Pre-Feed CMD
	•	Process - factory default. Sent commands from the host take precedence.
Process*
	•	Ignore - printer settings take precedence. The paper will not pre-feed.
	AX Fine Adjustment Command. Allows the selection of how the printer will respond to command
	for a position fine adjustment (AX).
AX Fine Adj. CMD
	•	Process - factory default. Sent commands from the host take precedence.
Process*
	•	Ignore - printer settings take precedence. The paper will not fine adjust.
	This menu is used to define the alignment of the image on the page.
	•	Center - factory default. Evenly spaced using the page width set in the configuration.
Page alignment
	•	Left - aligned to the left side. When printing in the Portrait mode, the image’s top will exit the
Center*
		printer first. Inverted Protrait mode, the image’s bottom will exit the printer first.
	Allows for fine adjustment of print the resolution used to convert coordinates of page elements
	(barcodes, font fields, graphic images,lines, boxes). The coordinates received from the host are
	in 1/10 millimeters and are converted to engine resolution (203 or 300 dpi).
Vert. DPI Adjust	In cases where the printed image length is incorrect, the vertical resolution value TGL uses for
0*	calculations can be fine adjusted between -100and +100. Negative values result in a lower dpi
	value and thus a shorter image. This adjustment does not affect the size of fonts and barcodes,
	only the coordinates.
	The factory default is 0.
	Allows the selection of how the printer will respond to command to the WS command for status
	responses from the printer.
Status Response
	•	Disable - factory default. Will not process commands.
Disable*
	•	Enable - will process commands.
		IGL EMULATION MODE (TABLE 4-14)
MENU		DESCRIPTION
	Permits entry into the EMULATION Mode.
EMULATION

Allows the specific emulation to be selected or if the Select option is chosen, the menu to follow will contain a list of emulation options available.

EMULATION

Select

GL408-412e Operator’s Manual 4-78