SATO GL4XXE manual Wireless Local Area Network Wlan Interface Mode Table, Menu, Description

Unit 4: Printer Configuration

WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)

MENU		DESCRIPTION
	Determines how the printer and/or NIC card respond when a job has been completed. The
	definition of a complete job is also determined by this setting.
	•	Standard - factory default. The NIC card responds to the host that the job is complete when
		the entire print job has been accepted by the printer.
Job Control
Standard*	•	Enhanced - the NIC card responds to the host that the job is complete when the entire job
		has not only been accepted by the printer, but alos completely printed.

•Off - without synchronization between the NIC and the printer. The NIC card is simply a pass-through and the printer tells the host when the job is complete.

	Determines whether the printer processes incoming data when it is in an offline state.
	• Disable - factory default. The printer does not process data while offline.
Offline Process
Disable*	• Enable - continues to process (but not print) the current network/parallel job while the printer
	is offline until in a buffer-near-full state.
	Is a menu subset of the Ethernet Port option. Will move into the Timeout menu.
ETHERNET PORT
Timeout
	This is the value used by the printer to time out from the current port and check the other selected
	Port Types for data print. When the printer has not received data from the host after a certain
Timeout
	period of time, it must timeout in order to service other ports.
10 sec*
	The factory default of 10 seconds with an allowable range of 1 to 60 seconds.

Determines when other ports areactive and able to communicate with the printer when the Ethernet interface is not in use.

	•	Data Timeout - factory default. The other ports (Parallel, Serial, USB) are able to send data
Switch Out On		to the printer when the timeout setting has been reached. This setting is adjustable via the
Data Timeout*		display menu item Timeout.

•Session Close - the other ports (Parallel, Serial, USB) are able to send data to the printer when the port has been closed. Example: If a RAW port of 9100 is open, the printer will not accept data from another interface until that port is closed by the host.

Is a subset of menus of the INTERFACES mode. Additional menus may be selected form here.

WLAN ADDRESS

IP Address

Subnet Mask

Gateway Address

MAC Address

DHCP

	This menu allows the IP Address for the TCP/IP protocol to be set in four three-digit segments
	(SEG1 through SEG4). If the IP Address is assigned by Bootp, ARP, or DHCP, it is dynamic and
	read only.
	When changing the IP Address, the printer resets the Network Interface Card (NIC) when the
IP Address
	printer is placed online. When the printer resets the NIC, the LCD displays “DO NOT POWER
XXX.XXX.XXX.XXX
	OFF”. After initialization is complete, the LCD displays “E-NET INIT” to signal that the NIC and
	printer are in the initialization process. When both the NIC and printer have completed
	initialization, the LCD displays “E-NET READY”.
	The factory default is 000.000.000.000 .

GL408-412e Operator’s Manual 4-59