SATO GL4XXE manual Wireless Local Area Network Wlan Interface Mode Table, Menu, Description

Unit 4: Printer Configuration

WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)

MENU	DESCRIPTION
	This menu allows the Subnet Mask for the TCP/IP protocol to be set in four three-digit segments
	(SEG1 through SEG4). If the Subnet Mask is assigned by Bootp, ARP, or DHCP, it is dynamic
	and read only.
	When changing the Subnet Mask, the printer resets the Network Interface Card (NIC) when the
Subnet Mask
	printer is placed online. When the printer resets the NIC, the LCD displays “DO NOT POWER
XXX.XXX.XXX.XXX
	OFF”. After initialization is complete, the LCD displays “E-NET INIT” to signal that the NIC and
	printer are in the initialization process. When both the NIC and printer have completed
	initialization, the LCD displays “E-NET READY”.
	The factory default is 000.000.000.000 .
	This menu allows the Gateway Address for the TCP/IP protocol to be set in four three-digit
	segments (SEG1 through SEG4). If the Subnet Mask is assigned by Bootp, ARP, or DHCP, it is
	dynamic and read only.
	When changing the Gateway Address, the printer resets the Network Interface Card (NIC) when
Gateway Address
	the printer is placed online. When the printer resets the NIC, the LCD displays “DO NOT POWER
XXX.XXX.XXX.XXX
	OFF”. After initialization is complete, the LCD displays “E-NET INIT” to signal that the NIC and
	printer are in the initialization process. When both the NIC and printer have completed
	initialization, the LCD displays “E-NET READY”.
	The factory default is 000.000.000.000 .
	This is an informational screen that displays the manufacturer’s assigned number. This number is
	unique for each NIC.
MAC Address
XXX.XXX.XXX.XXX
	Allows the DHCP protocol to be enabled or disabled through this menu.
	The factory default is Disable.
DHCP
Disable*	Note: Consult with your systems administrator for the appropriate setting.
	Is a subset of menus of the INTERFACES mode. Additional menus may be selected form here.
WLAN SETTING
Signal Strength
Operation Mode
SSID Name
Reset SSID Name
Min Xfer Rate
Channel
Ant. Diversity
Preamble
Power Mgt
Transmit Power
Internat. Mode
Auth Method
Reset WEP Keys
WEP Key 1
WEP Key 2
WEP Key 3
WEP Key 4
Default WEP Key
	This is an informational screen that displays the factory set signal strength of the wireles interface
	and cannot be changed.
Signal Strength
255%*

GL408-412e Operator’s Manual 4-60