SATO GL4XXE manual Local Area Network Lan Interface Mode, 8, LAN Interface Mode, 4-11

Unit 4: Printer Configuration

LOCAL AREA NETWORK (LAN) INTERFACE MODE

This chapter provides the programming sequences required for LAN interface setup. Use the keys of the printer’s operator panel to select and enter the required options.

Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

ATTENTION: Perform the following programming sequence only if this is the interface type to be used. Instead, refer to the appropriate interface programming chart.

Screens

only display if Admin User is enabled within the Advanced Mode

POWER
ONLINE
PARL / SBPL	INTERFACES		INTERFACES
	Host Interface*		Host Interface*
LINE	Host Interface		Host Interface
	Auto Switching*		Ethernet*
OFFLINE
		INTERFACES
ENTER		ETHERNET PORT
		ETHERNET PORT
INTERFACES		Timeout
		Timeout
		10 sec*
Interface
Mode		Switch Out On
ENTER
		Data Timeout*
INTERFACES
Ignore CR/LF
Item No. Check
BCC Check
History Buffer
Comm. Protocol			INTERFACES
Host Interface
ETHERNET PORT			ETHERNET SETTING
ETHERNET ADDRESS
ETHERNET SETTING			ETHERNET SETTING
Parallel Port
USB Port	ETHERNET ADDRESS		NetBIOS Protocol
Serial Port	IP Address
Printer Mgt
	Subnet Mask		NetBIOS Protocol
	Gateway Address
			Enable*
	MAC Address
Ignore CR/LF	DHCP
			ASCII Data Port
ENTER
	IP Address		1024*
Ignore CR/LF	XXX.XXX.XXX.XXX
			Keep Alive Timer
No*
	Subnet Mask		3 minutes*

	XXX.XXX.XXX.XXX
Item No. Check		Ethernet Speed
Disable*
	Gateway Address	Auto Select*
	XXX.XXX.XXX.XXX
BCC Check
Disable*		Job Control
	MAC Address	Standard*
	XXX.XXX.XXX.XXX
History Buffer
Temporary*		Offline Process
	DHCP	Disable*
	Disable*
Comm. Protocol
Status 5*

Host Interface

Auto Switching*

Figure 4-8, LAN Interface Mode

GL408-412e Operator’s Manual 4-11