Hardware and installation

iEM3100 / iEM3200 / iEM3300 series user manual

 

 

iEM3375 - Direct measurement up to 125 A and LonWorks communications

The various features of the iEM3375 are shown in the diagram below:

 

 

C/- DI

 

 

 

 

Service

 

 

 

 

ON

 

 

 

 

 

 

200

/kWh

 

 

 

Neuron ID: 000000000000

 

 

 

OK

 

ESC

S/N:0000000000

 

 

 

 

Config

Reset

 

 

 

 

 

N

N’

L1

L1’

L2

L2’

L3

L3’

A

Digital input

B

Communication port

C

Communications / LonWorks operations LED

D

Service pin

E

Display for measurement and configuration

F

Cancel

G

Confirm

H

Scroll

I

Current and voltage inputs (direct measurement up to 125 A)

J

Neuron ID

K

Energy pulsing LED (used to verify accuracy)

L

Status LED: on/off, error

 

 

DIN rail mounting and dismounting

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E in the USA or applicable local standards.

This equipment must only be installed and serviced by qualified electrical personnel.

Turn off all power supplying this device and the equipment in which it is installed before working on the device or equipment.

Always use a properly rated voltage sensing device to confirm power is off.

Replace all devices, doors and covers before turning on power to this equipment.

Do not exceed the device’s ratings for maximum limits.

Failure to follow these instructions will result in death or serious injury.

Mounting the meter on a DIN rail

1. Position the 2 upper slots on the rear of the meter onto the DIN rail.

2.Press the meter against the DIN rail until the locking mechanism engages. The meter is now attached to the rail. Make sure that the device is not tilted following installation.

22

DOCA0005EN-04

Page 22
Image 22
Schneider Electric iEM3200, iEM3300, iEM3100 user manual DIN rail mounting and dismounting, Mounting the meter on a DIN rail