Schneider Electric iEM3300 Configuring the meter using the M-Bustool, Communications via M-Bus

iEM3100 / iEM3200 / iEM3300 series user manual		Communications via M-Bus
	Tab name	Description
	RMS Measure	This tab provides power, current, and voltage values as well as frequency and power factor information.
	Meter Status	This tab provides information on the settings and status of the digital input, digital outputs and alarms as
		well as existing power system settings.

Configuring the meter using the M-Bus tool

1.Select Setup > Config to switch to configuration mode.

2.Set the values that you want to change then click Send for that value or section. For example, to change the nominal frequency, select a different value from the list then click Send in Set Wiring.

Some values may be unavailable based on existing settings.

NOTE: If Com. Protection is enabled, you may receive a message that the configuration failed.

Use the HMI to either: 1) configure the meter, or 2) disable Com. Protection then configure the meter using the tool.

The configuration screen has the following sections:

Section	Description
Set Wiring	Configure power system settings (for example, power system configuration and nominal
	frequency).
Set Digital Input	Set the digital input mode and pulse constant.
Set Digital Output	Enable / disable the digital output and set the control mode, pulse weight and duration.
Set Multi Tariff	Disable the Multi Tariff feature or set the control mode to by Communication and set the active tariff
	if the control mode is set to by Communication.
Set Power Alarm	Enable / disable to the overload alarm, enter the setpoint, and acknowledge alarms.
Reset	Reset partial energy and input metering accumulations.
Set Date Time	Set the date and time or send a time synchronization signal to set the meter to the computer time.
Set Baudrate	Set the baud rate.
Set Address	Set the meter address.

DOCA0005EN-04 87