Schneider Electric iEM3100, iEM3300 Meter configuration properties, Resets, Date/time setup

Communications via LonWorks				iEM3100 / iEM3200 / iEM3300 series user manual
	Network variable label	SNVT / UCPT type	Description
			Acknowledgement status (only Bit 1 is used):
	nvoAlmUnAckState	SNVT_count	0	= historic alarm is acknowledged by the user
			1	= historic alarm is unacknowledged by the user
	nvoAlmLastTime	SNVT_time_stamp	Timestamp of last alarm (DD/MM/YYYY hh:mm:ss)
	nvoAlmLastValue	SNVT_power_f	Value at last alarm
			Overload alarm configuration:
	nciAlmEnable	SNVT_count	0	= disabled
			1	= enabled
	nciAlmPkUpSetPt	SNVT_power_f	Active power alarm pickup setpoint in kW

Related topics

•See “Meter configuration properties” on page 68 for information on SCPTs and UCPTs that you can use to configure the meter.

•See “Echelon LonMaker plug-in for data display and meter configuration” on page 71 for instructions on using the LNS plug-in to configure the meter.

Resets

Network variable label	Type	Description	Action
		Resets all partial energy accumulators to 0:
		• Partial active energy import (nvoPartialkWh, nvoPartialWh)
		• Partial reactive energy import (nvoPartialkVARh, nvoPartialVARh)
		• Rate A active energy import (nvoTariffAkWh, nvoTariffAWh)
nciRstPartEnergy	SNVT_switch	• Rate B active energy import (nvoTariffBkWh, nvoTariffBWh)	To reset, set the state field to 1.
		• Rate C active energy import (nvoTariffCkWh, nvoTariffCWh)
		• Rate D active energy import (nvoTariffDkWh, nvoTariffDWh)
		• Active energy import phase 1 (nvoPh1kWh, nvoPh1Wh)
		• Active energy import phase 2 (nvoPh2kWh, nvoPh2Wh)
		• Active energy import phase 3 (nvoPh3kWh, nvoPh3Wh)
nciRstInMeterAcc	SNVT_swtich	Resets input metering accumulation (nvoInMeterAcc) to 0	To reset, set the state field to 1.

Meter configuration properties

You can configure the meter using the configuration properties listed in this section. However, it is recommended that you use the Echelon LonMaker plug-in if you are configuring the meter using LonWorks communications.

NOTE: If Com. Protection is enabled, you may receive an error response when you try to configure the meter over communications.

Related topics

•See “Com. Protection setting” on page 39 for more information on the Com. Protection feature.

•See “Echelon LonMaker plug-in for data display and meter configuration” on page 71 for instructions on using the LNS plug-in to configure the device.

Date/time setup

Function profile	UCPT	Struct Members	Range / options
		year	2000 - 2099
		month	1 - 12
nciCfgDateTime	UCPTDateTime	day	1 - 31
		hour	0 - 23
		minute	0 - 59
		second	0 - 59

68 DOCA0005EN-04