Schneider Electric iEM3200 Installing the M-Bustool, Accessing the meter using the tool, Resets

iEM3100 / iEM3200 / iEM3300 series user manual Communications via M-Bus

Use the information in the table below to acknowledge the overload alarm.

NOTE: E denotes the extension bit; the hex value assumes E = 1.

SND_UD	Data format	Manufacturer-specific VIFE			Range/options	Description
code		bin		hex1
07	00	E011 1000	B8		—	Acknowledge alarm

Resets

NOTE: E denotes the extension bit; the hex value assumes E = 1.

SND_UD	Data format	Primary VIFE		Manufacturer-specific VIFE			Description
code		bin	hex	bin		hex
07	00	—	—	E000 1101	8D		Resets partial energy accumulation to 0.
07	00	E110 0001	E1	—	—		Resets input accumulation to 0.

M-Bus tool for data display and meter configuration

The M-Bus tool provides a graphical user interface where you can view meter data and configure meter settings. To obtain the tool, go to www.schneider-electric.com and search for your meter model then select Downloads or contact your local Schneider Electric representative.

If you access a different meter without closing and re-opening the M-Bus tool, the fields displayed in the tool may not match the device you are accessing. The M-Bus tool may indicate a setting was changed without the setting on the meter actually changing.

NOTICE

INACCURATE DEVICE SETTINGS

Do not rely on the configuration information displayed in the M-Bus tool to determine if the associated device is correctly configured.

Failure to follow these instructions can result in inaccurate device settings and data results.

Installing the M-Bus tool

Before you install the tool, you need to download it from www.schneider-electric.com or obtain it from your sales representative.

1.Navigate to the location where you saved the installation files.

2.Double-click setup.exe. A welcome screen appears. Click Next.

3.Confirm the installation location for the tool. Click Browse if you want to select a different location. Click Next. A confirmation screen appears.

4.Click Next to begin the installation. A screen appears when the installation is complete.

5.Click Close.

Accessing the meter using the tool

Before you access the meter using the M-Bus tool, make sure that you:

•connect the meter to a level converter (for a direct serial connection) or a level converter and gateway (for connection via a serial or Ethernet network).

•set the address of the device to a value other than 0 (zero) using the HMI.

•install the M-Bus tool on your computer.

1.Select Start > Programs > Schneider Electric > Mbus config tool (or navigate to the location where you installed the program) and click SE_iEM3135_3235_3335 Mbus Tool to open the tool.

The login screen appears.

DOCA0005EN-04 85