Schneider Electric iEM3100, iEM3300, iEM3200 user manual Viewing meter data using the M-Bustool

Communications via M-Bus iEM3100 / iEM3200 / iEM3300 series user manual

2.Select the port on your computer that you are using to connect to the meter and select the baud rate that matches the meter’s configuration.

3.Click Test Com to open the communications port.

4.Type the device address in the Address field.

5.Select the communications mode that you want the tool to start in:

—Monitor(Automatic): The tool automatically sends read requests to and receives data from the meter. You can set the interval at which these read requests are sent.

—Monitor(Manual): You must manually send a read request to get data from the meter.

—Config: The tool opens in configuration mode.

You can change the mode from within the tool, if needed.

6. Click OK to start the M-Bus tool and access the meter.

Viewing meter data using the M-Bus tool

You can use two modes to view data from the device:

•Automatic mode: Select the update interval from the Interval dropdown list.

•Manual mode: Press Req_UD2 to request data from the meter.

To switch modes, select Setup > Monitor then select the mode you want to use.

The tool has the following tabs for viewing meter information:

Tab name	Description
	This tab provides basic information about the meter (for example, model and serial number) and any
Meter Info	active error codes. Click Clear to remove the error codes from the display.
	This does not resolve the errors.
Energy Measure	This tab provides total and partial energy, energy per phase and energy by tariff information, as well as
	input accumulations and the date and time of the last input metering and partial energy resets.

86 DOCA0005EN-04