BASIC OPERATIONS

8 Place the next set of original pagesand press the [START] key ().
9 When the last original page has been scanned, touch the [READ-END] key.

Repeat this step until all pages have been scanned. You can change the original size, resolution, and exposure settings as needed for each page.

If you take no action for about 1 minute (you do not press the [START] key ()), scanning automatically ends and the job is stored for transmission.

(Pg.No. 2)

L.

SS [READ-END]

READ-END

A beep sounds to inform you that the job has been stored for transmission.

[JOB STORED.] appears in the message display. (Dialing and transmission begin automatically when any previously stored jobs are completed.)

Note

If you do not touch the [READ-END] key to

 

complete the procedure, the screen will

 

 

automatically revert to the initial screen after

2

 

60 seconds. If desired, you can disable

 

automatic return to the initial screen by

 

changing a setting in the key operator

programs. (See "DISABLE DISPLAY TIMEOUT" in the key operator's guide.) When the screen reverts to the initial screen, the scanned originals will be transmitted.

If the memory becomes full while originals are being scanned, a message will appear and scanning will stop.

Note

The page that was being scanned when the memory became full will be cleared. To transmit only the originals

 

that have already been scanned, touch the [SEND] key. To cancel the transmission, touch the [CANCEL] key.

Depending on the content of the originals, the memory may become full before 100 pages are scanned.

When using job build mode, the number of originals scanned will appear in the display. When the count reaches 256 pages, it will reset to 0 and further scanned pages will be counted from 1.

When using job build mode, the original size can be changed between originals.

When scanning the first set of originals, the [ROTATE THE IMAGE 90 DEGREES] checkbox can be selected, however, from the second set of originals on, the selection cannot be changed until scanning is finished (the checkbox will be grayed out).

Direct transmission is not possible when using job build mode. A job build transmission takes place as a memory transmission even if Quick Online is enabled (transmission does not begin until all originals are scanned).

19