Sharp AR-M237 NORMAL COPYING, COPYING FROM THE DOCUMENT GLASS, 2 Close the RSPF, face down on the document glass, 1 Open the RSPF and place the original

NORMAL COPYINGCOPYING FROM THE DOCUMENT GLASS

Note If "AUDITING MODE" (p.56) has been enabled, enter your 5-digit account number.

1 Open the RSPF and place the originalface down on the document glass.

[How to place the original]

Align the corner or the original with the tip of the arrow () at the left rear corner of the glass as shown in the illustration.

Original scale Original scale

5-1/2" x	8-1/2" x
8-1/2"	14"
	8-1/2" x 11" R
8-1/2" x 11"	11" x 17"

• To load paper, see "LOADING PAPER"

Note (p.15). If you change the paper size in the tray, you will also need to change the tray's paper size and paper type settings. (p.19)

•The paper types for the auto paper selection function can be selected, or the function disabled, in the key operator programs. (See the "Key operator's guide".)

Manually selecting the paper size (paper tray)

If auto paper selection is disabled in the key operator programs, or if you wish to use a different size of paper than the original, touch the [PAPER SELECT] key and select the paper tray with the desired paper size. (The selected paper will be highlighted and the paper selecting screen will close.)

To close the screen without selecting a paper size, touch the [PAPER SELECT] key again.

READY TO COPY.			0
	PLAIN	11x17	AUTO
1.8½x11			EXPOSURE
2.8½x14	RECYCLED	PLAIN
			PAPER SELECT
		EXTRA IMAGE	100%
		ADJUST	COPY RATIO

2 Close the RSPF.

The original size appears in the touch panel.

4 Select the number of copies and any other desired copy settings, and then press the [START] key ().

ACC.#-C

Note

If the original size is not automatically detected, manually set the original size. (p.47)

• The number in the copy quantity display will

decrease by 1 each time a copy is made.

• If you are only making a single copy, the copy can be

3 Make sure that the same size of paper as the original is automatically selected.

			The selected tray is
ORIGINAL	8½x11	AUTO	highlighted. If the tray
			contains a different size of
		EXPOSURE
	8½x11	AUTO 8½x	paper than the original,
		PAPER SELE	"LOAD xxxx PAPER." will
8½x11
8½x14

100%	appear.
COPY RATI

Even if the message above is displayed, copying can be performed using the selected paper tray.

made with the copy number display showing "0".

• To clear a mistake, press the [CLEAR] key ( ).

•	Press the [CLEAR] key (	) to stop
Note	copying in the middle of a run.

•To repeat the same copy sequence for a

different original, simply replace the original and press the [START] key ().

•If copying stops because the tray has run out of paper, you can resume copying by touching the [PAPER SELECT] key and selecting the bypass tray or a paper tray that has the same size and type of paper loaded in the same orientation.

22