Sharp AR-M237 ROTATION SENDING SETTING, CALL TIMER AT MEMORY SENDING, RECALL IN CASE OF LINE BUSY, RECALL IN CASE OF, COMMUNICATION ERROR, QUICK ON LINE SENDING

KEY OPERATOR PROGRAMS

ROTATION SENDING SETTING

When transmitting a document, this setting allows you to rotate a vertically oriented 8-1/2" x 11" document to a horizontal orientation (8-1/2" x 11"R), or rotate an A4 document to A4R. The document is rotated clockwise. (8-1/2" x 11"R and A4R documents are not rotated.)

KEY OPERATOR PROGRAMS
			OK
ROTATION SENDING SETTING
	ORIGINAL	SENDING
	SET	DIRECTION
	81/2x11	81/2x11R
	A4	A4R

Rotation settings can be established separately for different document sizes. To disable a rotation setting, touch the checkbox of the appropriate setting to remove the checkmark.

This program is initially enabled for all paper sizes (factory default settings).

CALL TIMER AT MEMORY SENDING

When sending a fax by automatic transmission ("Storing transmission jobs (memory transmission)" (p.15)), this setting lets you select the amount of time that the machine waits before breaking the connection when the other machine does not respond to your machine's calling tone. If the other machine does not respond within this set time, your machine will automatically break the connection.

Time selections are [30 sec.], [45 sec.], and [60 sec.]. The factory default setting is "45 sec.".

RECALL IN CASE OF LINE BUSY

When sending a document, this setting is used to select whether your machine will automatically re-attempt the call when the other machine fails to answer or the line is busy. The number of recall attempts can be set from 1 to 14, and the interval between attempts can be set from 1 to 15 minutes in increments of 1 minute. To disable automatic recalling, select the [NO RECALL] checkbox.

The factory default settings are as follows:

•NUMBER OF TIMES: 2 (times)

•INTERVAL: 3 (min.)

RECALL IN CASE OF

COMMUNICATION ERROR

When sending a document, this setting is used to select whether your machine will automatically re-attempt the call if the transmission fails due to a line error. One recall attempt or no recall attempts can be selected, and the interval until the attempt can be set from 0 to 15 minutes in increments of 1 minute.

The factory default settings are as follows:

•NUMBER OF TIMES: 1 (times)

•INTERVAL: 1 (min.)

QUICK ON LINE SENDING

When this program is enabled and memory transmission is selected, the machine will call the receiving machine while the original pages are being scanned and begin transmission from pages that have finished scanning.

When the program is disabled, transmission will not begin until all pages have been scanned (with the exception of manual transmission and direct transmission). ("Quick On-line" (p.14))

This program is initially enabled (factory default setting).

DEFAULT SENDING MODE

This program is used to select [MEMORY TX] or [DIRECT TX] for the default transmission mode. For more information on these modes, see page 14. The factory default setting is "MEMORY TX".

AUTO COVER SHEET

When this program is enabled, a cover page is automatically generated and added to each fax transmission. The cover page shows the date, time, destination name, destination fax number, sender's name, sender's fax number, number of pages, and a message if the message function is selected. A cover sheet cannot be added when scanning a document into polling memory or F-code polling memory, or when performing polling, direct transmission, relay broadcast transmission, F-code relay broadcast transmission, or manual transmission.

This program is initially disabled (factory default setting).

SLOW SCAN MODE

When this program is enabled, thin-sheet scanning is selected by default when an original is scanned using the RSPF.

Thin-sheet scanning uses a slower scanning speed to prevent thin originals from misfeeding.

This program is initially disabled (factory default setting).

100