Sharp AR-M237 7 Touch the [OK] key, 10 Touch the [OK] key, 6 Enter the numbers of the end receiving machines

REC.

REC.

ADDRESS REVIEW

PROGRAMMING

6 Enter the numbers of the end receiving machines.

Touch a key and then enter the number of an end receiving machine as explained below.

After entering a number, touch the [NEXT ADDRESS] key to enter the number of the next end receiving machine.

DIRECT ADDRESS / RELAY GROUP				NEXT			EXIT
							OK
RECIPIENT
	DIAL	REC.	RAPID			REC.
	SPEED	REC.	GROUP			REC.
					ADDRESS REVIEW

[DIAL] key

Enter the fax number of the receiving machine with the numeric keys.

[RAPID] key

Touch this key to enter a rapid number from 01 to 99 that is stored in the relay machine. You can also enter a 3-digit rapid number from 001 to 099 (enter the lower two digits of the number).*

Touch the or key to enter the number. Continuing to touch the key makes the number change quickly.

[SPEED] key

Touch this key to enter a speed dial number from 00 to 99 that is stored in the relay machine. You can also enter a 3-digit rapid number from 100 to 199 (enter the lower two digits of the number).*

Touch the or key to enter the number. Continuing to touch the key makes the number change quickly.

[GROUP] key

Touch this key to enter a group key number from 01 to 99 that is stored in the relay machine.

You can also enter a 3-digit rapid number from 201 to 299 (enter the lower two digits of the number).*

Touch the or key to enter the number. Continuing to touch the key makes the number change quickly.

*The numbers entered will vary depending on the model used for the relay machine. For more information, consult your SHARP service center. (Also see the operation manual for copier.)

8 Repeat steps 6 and 7 until all end receiving machines are entered.

9 To check the entered numbers of the end receiving machines, touch the [ADDRESS REVIEW] key.

A list of the entered end receiving machines is

displayed.

You can delete a machine by touching it.

When a message appears asking if you want to delete the destination, touch the [YES] key.

Touch each tab at the bottom of the list to show the numbers on that tab.

10 Touch the [OK] key.

The destination/relay group storing screen appears.

11 If you are finished storing relay groups, touch the [EXIT] key.If you wish to store another relay group, touch the [NEXT] key.

If you touch the [EXIT] key, you will return to the screen of step 4 on page 66.

If you touch the [NEXT] key, the screen for storing a new relay group appears.

7 Touch the [OK] key.

The screen for entering

CANCEL	OK	the numbers of the end
		receiving machines
		appears.

76