Network Settings

If your network requires that you assign a static (permanent) IP address to the machine, follow the steps below to disable DHCP (automatic IP address assigment) and configure the network settings.

Consult your network administrator for the information that must be entered. After DHCP is disabled, the settings that must be configured appear in the following order (these settings only appear when DHCP is set to NO):

IP ADDRESS SUBNET MASK DEFAULT GATEWAY DNS (PRIMARY) DNS (SECONDARY)

FUNCTION

1Press , then until

[NETWORK SETTING] appears.

2Press twice. [DHCP] will appear.

3Press for NO (the machine will not obtain an IP address automatically).

[IP ADDRESS] will appear.

(If you wish to configure a different

setting, press or .)

4Press .

5Press the number keys to enter the required number.

Network Settings

Three digits must be entered in each

 

 

segment of the number (the

 

 

segments are separated by periods).

 

 

If a segment does not have 3 digits,

to

mail-E

enter zeros as needed.

Scan

 

 

Example: IP address = 192.168.1.2

 

 

You must enter: 192.168.001.002

2.

 

 

 

If you make a mistake, press

 

 

to move the cursor to the mistake

 

 

and enter the correct number.

 

 

6When finished entering the number,

press .

7The next setting will appear in the display. Repeat Steps 4 through 6 to configure the next setting, or press

STOP

to exit.

Initializing the network settings

If you need to return the network settings to their initial state, follow the steps below.

Initializing the settings enables DHCP and clears the IP address and related settings.

1 Press

FUNCTION

until

, then

[NETWORK SETTING] appears.

2 Press twice, then to

show [INITIALIZE SETTINGS].

3 Press twice.

25

Page 27
Image 27
Sharp UX-B800 manual Network Settings, Initializing the network settings