•If you are on a Flash-type PBX and

R

are dialling out, press , press

FUNCTION

to insert a pause, and then

enter the number of the receiving machine.

•If you are on a PBX and must dial a number to dial out, enter the number,

FUNCTION

press to insert a pause, and

then enter the number of the receiving machine.

3Check the display. If the number

shown is correct, press .

•If the number is not correct, press

STOP

to clear the incorrect digits, and then re-enter the correct digit(s).

Redial

You can automatically redial the last number dialled on the machine.

1Load the document(s).

RESOLUTION/

• If desired, press RECEPTION MODE to set the resolution and/or contrast.

2Press once. Make sure the display shows the number you wish to dial.

Sending a Fax: Auto Dialling

3If you are sending a fax, press

. Dialling begins.

If you are making a phone call, lift the handset. Dialling begins.

Note: If the transmission is unsuccessful and [DOCUMENT JAMMED] appears in the display, remove the document as explained on page 67.

Automatic redialling

If you use auto dialling (including Direct Keypad Dialling) to send a fax and the line is busy, the machine will automatically make three redial attempts at intervals of five minutes.

During this time, [RECALLING] will appear in the display, followed by the attempt number. You will not be able to dial any other locations while the message appears.

♦To clear the message and stop

STOP

automatic redialling, press .

Under certain conditions, automatic redialling may stop before three redialling attempts are made.

Sending

Faxes

3.

 

33

Page 35
Image 35
Sharp UX-B800 manual Redial, Automatic redialling, press