Siemens 1054 operating instructions At initialization, your telephone is set for tone dialing

8.11.96

1054K04.FM

Gigaset 1054, GBR: A30852-X954-B101-1-7619

Putting Into Service Comfort Mobile Unit

Viewing and Setting the Dialing Mode

The German Telekom AG offers two different dialing modes for telephones:

●Dial pulsing system (Dial Pulsing System = DPS)

●Dual-tone (multifrequency system = DTMF)

At initialization, your telephone is set for tone dialing.

Tone dialing (DTMF) is, however, only possible if your telephone lines are connected to a new digital switching exchange. The German Telekom AG has, however, not yet completely finished converting all telephone lines in Germany to digital switching exchanges.

Determining the Dialing Mode of Your Telephone Connection:

Press the connect key and dial any digit (for example, 2).

If you still hear the same dial tone after dialing the digit, you will have to switch the dialing mode. The dialing mode must be individually set for both external telephone lines:

1.In the idle state, press the ßkey and select “Service” from the main menu.

2.In the service menu, select “System Settings” and enter the system code. (See also page 115).

Line data

External 1/2

After the correct system code is entered, the following display appears:

Scroll, using NEXT ...

until “Line data” appears in the 1st line; confirm with OK.

Scroll, using NEXT, to select the external telephone line for which the call allocation is to be set,

e.g. External 1; confirm with OK.

Sys cd/Mn sys cd

Duration/units Call barring

NEXT OK

External 1

External 2

NEXT OK

Pause duration

Dial data

Call data

NEXT OK

Dial data

Dialing mode

Act.: DTMF/Fl0,25

New: DPS/ground

New: DTMF/ground

New: DTMF/Flash

- - - - - - - -

Confirm “Dial data” with OK..

Confirm “Dialing mode” with OK.

The menu for setting the dialing mode is displayed (complete menu at left).

Dialing mode

Time for ground Time for flash

NEXT OK

Act.: DTMF/Fl0,25

New: DPS/ground

New: DTMF/ground

NEXT OK

Note:

●In order to operate your Gigaset 1054 on a main station connection, you only need the “DTMF/Flash 0.25” or “DPS/ground” settings.

The additional dialing mode settings are for operation of the Gigaset 1054 as part of a telephone network (see page 137)ff.

26