Siemens 1054 operating instructions Set the COS for Internal Stations, Incoming Authorization

28.10.96

1054K07B.FM

Gigaset 1054, GBR: A30852-X954-B101-1-7619

Operation with Comfort Mobile Unit Lock

Set the COS for Internal Stations

By setting the Class of Service for every registered mobile unit, you can stipulate which internal stations can place external toll calls.

At the time of initialization, all devices are fully trunk authorized.

1.Full Trunk Authorization (= status at initialization) Incoming and outgoing external calls are permissible.

2.Incoming Authorization

It is only possible to accept incoming calls. All external dialing is blocked.

3.Internal Authorization

Only internal calls are possible. All external dialing is blocked. You can initiate a consultation call to an authorized internal station, but cannot transfer an external call; you will receive a callback in that case.

1.In idle status, push the ßkey and select “Service” from the main menu.

2.In the Service menu, select “System settings” and enter the system code (see also page 115).

Equipment data

After the correct system code is entered, the following display appears:

Scroll through the menu with NEXT ...

until “Equipment data” is on the 1st line; then select with OK.

Scroll through the menu with NEXT ...

Sys cd/Mn sys cd

Duration/Units Call barring

NEXT OK

Autom. seizure

Call pickup Access rights

NEXT OK

Access rights

Internal X

until “Access rights“ is on the 1st line; then select with OK.

Using NEXT, find the internal stations for which the access rights are to be set and

select them with OK; here, internal station 0.

You can now stipulate the COS.

Internal 0

Internal 1

Internal 2

NEXT OK

Active: trunk acc

New: incoming

New: internal

NEXT OK

Note:

●If your Gigaset 1054 is being operated on only one telephone line, then you should set “Internal authorization” for the 2nd telephone line.

113