Siemens MC55 AT manual ATZ Set all current parameters to user defined profile, ATZvalue

2.7 ATZ Set all current parameters to user defined profile

ATZ sets all current parameters to the user profile stored with AT&W. If a connection is in progress, it will be ter- minated.

All defined GPRS contexts which are not activated or not online will be undefined (see AT+CGDCONT). The user defined profile is stored to the non-volatile memory.

Syntax

Exec Command

ATZ[<value>]

Response(s)

OK

Reference(s)

V.250

PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last

! % % % % % ! ! !

Parameter Description

<value>(num)

[0] Reset to user profile

Notes

•First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W), this profile will be loaded afterwards.

•Any additional commands on the same command line may be ignored. A delay of 300 ms is required before next command is sent, otherwise "OK" response may be corrupted.

MC55_ATC_V04.00	Page 36 of 475	3/17/06
Confidential / Released