Siemens MC55 AT Atsnfv Set loudspeaker volume, Atsnfv=?, Atsnfv?, Snfv outStep, ATSNFV=outStep

17.17AT^SNFV Set loudspeaker volume

AT^SNFV can be used to set the volume of the loudspeaker to the value <outCalibrate> addressed by <out- Step>. The read and write commands refer to the active audio mode. The write command works only in audio modes 2 to 6.

Syntax

Test Command

AT^SNFV=?

Response(s)

^SNFV: (list of supported <outStep>s)

OK

Read Command

AT^SNFV?

Response(s)

^SNFV: <outStep>

OK

Write Command

AT^SNFV=<outStep>

Response(s)

OK ERROR +CME ERROR

Reference(s)

SIEMENS

PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last

! % % % % % ! ! !

Parameter Description

<outStep>(num)

The actual volume of each step is defined by the parameter <outCalibrate>, which can be set with AT^SNFO. 0...4(P)

Notes

•Any change to <outStep> takes effect in audio modes 2 to 6. That is, when you change <outStep> and then select another mode with AT^SNFS, the same step will be applied. Nevertheless, the actual volume can be quite different, depending on the values of <outCalibrate> set in each mode. The only exception is audio mode 1 which is fixed to <outStep>=4.

•<outStep> is stored non-volatile when the ME is powered down with AT^SMSO or reset with AT+CFUN=1,1.

<outStep> is not stored by AT^SNFW.

•<outStep> can also be changed by AT^SNFO (Section 17.13) and AT+CLVL (Section 17.4).

MC55_ATC_V04.00	Page 422 of 475	3/17/06
Confidential / Released