Monaco Technical Reference Spectrum Signal Processing
JTAG Debugging
38 Part Number 500-00191
Revision 2.00
For multiple Monaco boards, the JTAG cable of the external debugger should be
connected to the JTAG IN of the first board. The JTAG OUT of the first board should be
connected to the JTAG IN of second board. The JTAG OUT of the second board should
be connected to the JTAG IN of third board and so on. The JTAG OUT connector of the
last board is not connected to anything.
Note:
All hardware must be powered off before the JTAG cable are connected
and the JTAG chain is set up.